Flat belt conveyor GAL-25-K-W
The angled belt conveyor GAL-25-K-W has a frame with only 25 mm height. It can therefore be used even in very confined spaces.
The very rigid TorsioDur frame gives a high resistance against torsion which results in high reliability in spite of very small dimensions.
Equipped with a corrugated edge belt it can handle even the smallest parts without any danger of jamming or damaging them.
The angle of inclination can be infinitely adjusted between 40 and 60° from the ground.
The frame has grooves for sliding blocks with M-6 threads on both sides, where additional accessories can be fixed . An overview of accessories available in our standard programme can be found on page 63 and onwards.
The length of the horizontal and the rising section of the conveyor can be adapted to the specific needs of each application. The total length however should not exceed 3 metres.
Hoppers and side rails can be added to the GAL-25-K-W when needed. They will ensure a safe transport of the goods.
In standard configuration the horizontal section has small casters, so the conveyor can easily be moved. A double support is fixed to the rising section, as shown in the picture above. An H-shaped support on wheels with security brakes can also be used.
- Technical Specifications and Accessories
Useable belt widths(between the corrugated edges) / Total belt width:
140/300 mm, 190/350 mm, 240/400 mm, 290/450 mm or 340/500mm.
Horizontal distance between axes, A1: 500 to 2.500 mm. All intermediate lengths possible.
Rising distance between axes, A2: 500 to 2.500 mm. All intermediate lengths possible. Total length A1 + A2: no more than 3.000 mm.
Drive with constant belt speed:
v = approx. 3,9 / 7,2 / 10,8 / 14,3 / 21,5 or 30,7 m/min.
Other belt speeds are possible on request. Connection for 220/240 - 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.
Drive with infinitely adjustable belt speed:
v = approx. 1,6-5,7 / 2,9-10,5 / 4,3-15,7 / 5,8-20,9 / 8,6-31,4 or 12,3-44,9 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.
Geared motor position:
Pulling the belt at its side, on the left or right.
Total belt load:
Standard is of 15 kg. Higher loads are possible on request.
